NanoSound DAC Basic
NSOUNDBASIC
US$35.99
Out of stock
1
Product Details
UPC:
750783918879
Brand:
NANOMESHER
This product has been replaced by 2nd Generation DAC 2 - Now Available
Rated 5-star by Official Raspberry Pi Magazine
NanoSound is a Raspberry Pi audio add-on board for audiophiles. With a 24bit / 112dB Hi-Fi Audio DAC (Digital to Analog Converter) onboard, it dramatically improves the audio quality of your Raspberry Pi.
Officially supports
A Headphone and Speaker Amp add-on and complete kit are also available
SPECIFICATION
- Texas Instruments PCM5122 DAC
- 192kHz Sampling Rate / 24bit Resolution Burr-Brown DAC for best sound quality
- Hardware volume control for best quality using “alsamixer”
- Texas Instruments TPS7A4700 Ultra Low Noise Voltage Regulator
- Switchable Power Option
- Power from a single microUSB port or independently
- Raspberry Pi Power switch
- Turn on and Gracefully shut down Raspberry Pi System
- 6 GPIO buttons for Media Control
- Infrared Receiver and Remote Control (LIRC compatible)
- Works with all Raspberry Pi with 40pin Header (Including Pi 3 Model B+, Pi 3 Model B , Pi 2 Model B, Pi 1 B+)
DEMO VIDEOS
Guide
NanoSound DAC Model Difference
OPTIONAL AMP^2
The new amp add-on board for NanoSound DAC, NanoSound Amp^2 (Pronounced as "Amp Square"), include both a headphone amplifier as well as a very efficient 5W speaker amplifier.
It runs very cool due to its up to 90% efficiency allowing the whole unit (Raspberry Pi + NanoSound DAC + NanoSound MiniAmps) to be powered by one single microUSB cable (or individually if you choose to). It's surprisingly loud and is enough to power a large room or a small lounge.
Save this product for later
Display prices in:
USD