NANOSOUND AMP^2

Following the success of NanoSound DAC, Nanomesher continues to develop our Raspberry Pi Audio range. Here we present NanoSound AMP^2 - A Very Efficient Headphone + Speaker Amp Add on for your NanoSound DAC. 

    

WHAT IS NANOSOUND AMP^2

The new amp add-on board for NanoSound DAC, NanoSound Amp^2 (Pronounced as "Amp Square"), include both a headphone amplifier as well as a very efficient 5W speaker amplifier.
It runs very cool due to its up to 90% efficiency allowing the whole unit (Raspberry Pi + NanoSound DAC + NanoSound Amp^2) to be powered by one single microUSB cable with 5V 2A (or  individually if you choose to). It's surprisingly loud and is enough to power a large room or a small lounge as demonstrated.

NanoSound Amp^2 Fitted on NanoSound DAC

SPECIFICATION

  • Switch On/Off via onboard bottons on the NanoSound DAC
  • Onboard relay rated up to 2A
  • Powered by single microusb or individually
    • 4 layered PCB designed to eliminate internal interference from Pi

    Headphone Amp

    • Input Voltage: 5V
    • Output Power: 24mW @20Ω, 22mw @32Ω
    • Signal-To-Noise Ratio (SNR): 100db @20mW
    • Total Harmonic Distortion + Noise (THD+N): 0.01% @25mW

    Speaker Amp

    • Input Voltage: 5V
    • Output Power: 5W @2Ω, 3W @4Ω
    • Efficiency: 90% @8Ω , 85% @4Ω, 80% @2Ω
    • Signal-To-Noise Ratio (SNR): 90db
    • Total Harmonic Distortion + Noise (THD+N): 0.15%

    DOWNLOAD

     

    Check out our AUDIO Products

     

    Check out our DIY Products