NanoSound Player Kit

NSOUNDPLAYER

NanoSound Player Kit NSOUNDPLAYER

Now comes with Pi 3 model B+

The NanoSound Player is a Audiophile Network Music Player with integrated OLED Display, control buttons and remote control. It can even drive your loudspeakers directly with the NanoSound Amp^2 add on!

It will only take minutes to assemble this kit and turn it into a Network Audio Player - No soldering required.

The kit includes:

  • Raspberry Pi 3 Model B+
  • Raspberry Pi Official Power Supply (UK, Europe, Australia and the United States Plug included)
  • NanoSound DAC Pro with Remote Control and OLED Display
  • Sandisk Ultra 16/64/200 GB microSDHC

Optionally you can add:

  • NanoSound Amp^2 Speaker & Headphone Amplifier
    • Use this to power your speakers and large headphones directly
  • NanoSound Case (Black /White)

Volumio Setup Guide:

NanoSound DAC - Specification

  • Texas Instruments PCM5122 DAC
  • 192kHz Sampling Rate / 24bit Resolution Burr-Brown DAC for best sound quality
  • Hardware volume control for best quality using “alsamixer”
  • Texas Instruments TPS7A4700 Ultra Low Noise Voltage Regulator
  • Switchable Power Option
  • Power from a single microUSB port or independently
  • Raspberry Pi Power switch
  • Turn on and Gracefully shut down Raspberry Pi System
  • 6 GPIO buttons for Media Control
  • Infrared Receiver and Remote Control
  • LIRC compatible
  • 1.3" OLED display with multi-language support. Resolution: 128 x 96

NanoSound Amp^2 - Specification (Optional)

  • 5W Speaker + Headphone Amplifier
  • Switch On/Off via onboard bottons on the NanoSound DAC
  • Onboard relay rated up to 2A
  • Powered by single microusb or individually
  • 4 layered PCB designed to eliminate internal interference from Pi

Headphone Amp

  • Input Voltage: 5V
  • Output Power: 24mW @20Ω, 22mw @32Ω
  • Signal-To-Noise Ratio (SNR): 100db @20mW
  • Total Harmonic Distortion + Noise (THD+N): 0.01% @25mW

Speaker Amp

  • Input Voltage: 5V
  • Output Power: 5W @2Ω, 3W @4Ω
  • Efficiency: 90% @8Ω , 85% @4Ω, 80% @2Ω
  • Signal-To-Noise Ratio (SNR): 90db
  • Total Harmonic Distortion + Noise (THD+N): 0.15%

Guide

Kit Install Guide:

US$169
In stock
Case

3D Printed Case (Black) (25)
3D Printed Case (Silver) (25)
3D Printed Case (White) (25)
No Case (0)
Amplifier

Amp^2 - Speaker & Headphone Amp (25)
No Amp (0)
Storage

16GB (0)
64GB (45)
200GB (130)

With black case
With white case
Without case
Kit content (Case and Amp are optional)
Included power supply
Headphone not included

 

Check out our AUDIO Products

Check out our STEM Products

 

Check out our DIY Products