NanoSound Player Kit

Out of stock
Product Details

Now comes with all new Raspberry Pi 3 model B+!

The NanoSound Player is a Audiophile Network Music Player with integrated OLED Display, control buttons and remote control. It can even drive your loudspeakers directly with the NanoSound Amp^2 add on!

Officially supports

It will only take minutes to assemble this kit and turn it into a Network Audio Player - No soldering required.

The kit includes:

  • Raspberry Pi 3 Model B+
  • 5V 2.5A Power Supply for Raspberry Pi (UK, Europe or United States Plug )
  • NanoSound DAC with Remote Control and OLED Display
  • Sandisk Ultra 16/64/200 GB microSDHC
  • NanoSound 3D Printed Case

Optionally you can add:

  • NanoSound Amp^2 Speaker & Headphone Amplifier
    • Use this to power your speakers and large headphones directly

Volumio Setup Guide:

NanoSound DAC - Specification
  • Texas Instruments PCM5122 DAC
  • 192kHz Sampling Rate / 24bit Resolution Burr-Brown DAC for best sound quality
  • Hardware volume control for best quality using “alsamixer”
  • Texas Instruments TPS7A4700 Ultra Low Noise Voltage Regulator
  • Switchable Power Option
  • Power from a single microUSB port or independently
  • Raspberry Pi Power switch
  • Turn on and Gracefully shut down Raspberry Pi System
  • 6 GPIO buttons for Media Control
  • Infrared Receiver and Remote Control
  • LIRC compatible
  • 1.3" OLED display with multi-language support. Resolution: 128 x 96
  • Pure Copper RCA Sockets

NanoSound Amp^2 - Specification (Optional)

  • 5W Speaker + Headphone Amplifier
  • Switch On/Off via onboard bottons on the NanoSound DAC
  • Onboard relay rated up to 2A
  • Powered by single microusb or individually
  • 4 layered PCB designed to eliminate internal interference from Pi

Headphone Amp

  • Input Voltage: 5V
  • Output Power: 24mW @20Ω, 22mw @32Ω
  • Signal-To-Noise Ratio (SNR): 100db @20mW
  • Total Harmonic Distortion + Noise (THD+N): 0.01% @25mW

Speaker Amp

  • Input Voltage: 5V
  • Output Power: 5W @2Ω, 3W @4Ω
  • Efficiency: 90% @8Ω , 85% @4Ω, 80% @2Ω
  • Signal-To-Noise Ratio (SNR): 90db
  • Total Harmonic Distortion + Noise (THD+N): 0.15%


Kit Install Guide:

Save this product for later