This product has been replaced by 2nd Generation DAC 2 - Now Available

Rated 5-star by Official Raspberry Pi Magazine

NanoSound is a Raspberry Pi audio add-on board for audiophiles. With a 24bit / 112dB Hi-Fi Audio DAC (Digital to Analog Converter) onboard, it dramatically improves the audio quality of your Raspberry Pi.

Officially supports

A Headphone and Speaker Amp add-on and complete kit are also available

Full Product Detail

SPECIFICATION

• Texas Instruments PCM5122 DAC
  • 192kHz Sampling Rate / 24bit Resolution Burr-Brown DAC for best sound quality
  • Hardware volume control for best quality using “alsamixer”
• Texas Instruments TPS7A4700 Ultra Low Noise Voltage Regulator
• 1.3" High Resolution OLED Display
• Switchable Power Option
  • Power from a single microUSB port or independently
• Raspberry Pi Power switch
  • Turn on and Gracefully shut down Raspberry Pi System
• 6 GPIO buttons for Media Control
• Infrared Receiver and Remote Control (LIRC compatible)
• Works with all Raspberry Pi with 40pin Header (Including Pi 3 Model B+, Pi 3 Model B , Pi 2 Model B, Pi 1 B+)

DEMO VIDEOS

Guide

• Quick setup Guide
• Volumio Guide
• Support Page
• Our youtube channel

NanoSound DAC Model Difference

OPTIONAL AMP^2

It runs very cool due to its up to 90% efficiency allowing the whole unit (Raspberry Pi + NanoSound DAC + NanoSound MiniAmps) to be powered by one single microUSB cable (or individually if you choose to). It's surprisingly loud and is enough to power a large room or a small lounge.