Forum

Forum breadcrumbs - You are here:ForumNanoSound: NanoSound DAC / Player HelpAmp 2
Please or Register to create posts and topics.

Amp 2

Ciao nanomasher, vorreii sapere c'è come amplificatori il DAC nanosound basic supporta solo amp2 o anche altri classe D? Scusa la mia ignoranza ma non sono pratico e vorrei arricchire il mio HiFi

Hi Criss,

Nanomesher DAC has RCA and 3.5mm analog output, so any amplifier with such analog input will work.

Nanosound DAC

Thank you

 

Hi,

Can you share connection pin of Amp^2 detail (left,right, power...)

Thanks and best regards,

The Amp^2 connections are here: https://nanomesher.com/nanosound-amp2-support/

 

For a DAC2 + Amp^2, do the RCA jacks need a dummy load when they are not being used?

If a dummy load is not required, then will a DAC2 + Amp^2 work "better" with a dummy load on the RCA jacks?

 

Dummy load is not required and better without it. thanks!

Hi,

Is it jumper V3 use for set Amp to mode class AB? and any note when we use mode class AB instead class D?

Thanks,

Uploaded files:
  • 06EADFBE-915A-4CE9-8B63-CBBF27FE59EB.jpeg
Quote from zzziamond on May 17, 2019, 12:28 am

Hi,

Is it jumper V3 use for set Amp to mode class AB? and any note when we use mode class AB instead class D?

Thanks,

No, it's just for turning the Amp permanently rather than controlled from Pi.

Hopefully I could find the answers here. Thank you for sharing this. Glad I saw this post. I’ve been searching a lot lately. But I haven’t found the right answers. While I was searching I found this  source And also this https://fireemblem.io/.